This fifty year old Ceramic tiled floor was installed in the communal parts of a small block of flats in Poole, Dorset. The tiles had not been given a deep clean in a long while and were now ingrained with dirt from many years of wear.
Cleaning Ceramic Floor Tile and Grout
To clean the tiles a strong dilution of Tile Doctor Pro-Clean was applied a left to soak into the tile for some time before working it into the floor using a rotary machine fitted with a black scrubbing pad. During this process it became clear that there was evidence that the tiles had been previously sealed using a metallised emulsion. This needed to be completely removed by buffing the floor and then steaming it; steaming also removed a myriad of paint spots that had accumulated over the years.
At this stage we took the opportunity to give the grout a good scrub with more Pro-Clean and a stiff hand brush before removing the cleaning solution with a wet vacuum and giving the entire floor a thorough rinse to remove and trace of cleaning product.
Sealing Ceramic Floor Tiles
The tiles were left to dry off overnight and we came back the next day to see if further work was needed. Now normally Ceramic tiles have a glazed surface that a sealer cannot take to however these tiles being were very old and the glaze had been worn off so sealed a small test are to see if it would take. The test was successful so I proceeded to seal the whole floor using Tile Doctor Colour Grow.
Due to the age of the tiles some were more faded than others which I could do nothing about however they looked generally clean and bright after restoration and the new Colour Grow sealer should provide protection for years to come.
This 50m2 Tumbled Marble tiled floor in Dewlish, near Dorchester had not been deep cleaned and re-sealed for at least five years and showed signs of the normal wear and tear associated with a busy kitchen/dining room and a dog that enjoyed muddy walks. The old sealer was now breaking down allowing dirt to become ingrained in the Marble making it difficult to clean.
Stripping a Tumbled Marble Floor
To restore the surface finish it needed to be burnished using a set of diamond encrusted burnishing pads. The pads come in a number of different grades from coarse (used to strip off sealers and dirt from the Marble) too very fine (used for final polishing) and are applied one after another starting with the coarse pad and moving through to the very fine pad towards the end. Each stage requires a little water which captures the soil and is rinsed away and removed with a wet vacuum. This process completely removed the old sealer and surfaces scratches with a new shine. The floor was given a thorough wash down at this point again using a wet vacuum to remove as much water as possible from the surface before leaving it to dry for the evening.
Sealing Tumbled-Marble Tiles
The next day the Marble had dried and I started to seal the tiles using two coats of Tile Doctor Colour Grow sealer which was first applied to a couple of test tiles first to ensure it gave the effect the customer was looking for.
Colour Grow is a colour enhancing sealer that brings out the natural colour of the tile and certainly the customer was pleased with the results so the sealing work continues until the whole 50m2 floor had been sealed with two coats.
When the whole fifty square metres of floor had been sealed using Colour Grow the effect was dramatic and the owners were so pleased with the result that they invited over a friend with a similar stone floor who immediately asked for her floor to be done in the same way.
Tumbled Marble Floor Restoration in Dewlish near Dorchester