Slightly unusual job this one involving a Limestone tiled floor at a house in Canford Cliffs which is a beautiful part of Dorset near Poole overlooking the sea. The tiles had only recently been laid and then sealed by a tiler, unfortunately however too much sealer had been applied and it had been allowed to dry on the surface of the tiles causing a smeared and messy appearance.
Removing Sealer from Limestone Floor Tiles
To remove the sealer from the floor the surface needs to be cut back and re-polished using of a set of diamond encrusted burnishing pads fitted to a rotary machine. You start with a coarse pad with a little water, then a medium pad, fine pad and finish with a very fine polishing pad, this takes some time but the effect it quite transforming, it does build up slurry on the floor so it all needs to be rinsed down using water and a wet vacuum to remove the liquids the wet vacuum also helps to get the floor dry.
Sealing Limestone Floor Tiles
The floor was left to fully dry overnight and I returned the next day to seal the Limestone tiles using a coat of Tile Doctor Colour Grow carefully applied using a B&Q paint pad. Colour Grow is an impregnating sealer that fills the pores in the Limestone to prevent other contaminates staining the stone; it’s also a colour enhancing sealer that lifts the natural colours in the Limestone. Once dry the floor was buffed using a Numatic buffing machine fitted with a soft white pad to give a perfect finish to the floor.
Tile Doctor to the rescue again, Tilers should stick to Tiling and leave the sealing to us.